Electric valve controller (manipulator)
AJ-BST-G series electric valve controller. With unique intelligent function, it can automatically cut off the power when the valve is in place. It can prevent the valve from closing when it is not in place. The most technologically advanced electric valve controller.Basic parameters:
|Operating Voltage||DC lOV -14V|
|Working current (12VDC)||lOOmA (normal)-600mA (maximum)|
|Torque||40kg / cm|
|surroundings||-lO "C-55" "C|
|Pressure range||86-106 Kpa|
|Service life||5 years|
- 1. Install the controller on the valve as shown in the installation diagram. Make sure that the axis of the controller is aligned with the axis of the valve.
- 2. The red wire of the controller is connected to the positive pole of the power supply. The black wire is connected to the negative pole of the power supply, and the valve will close the valve. Until the valve is in place, the valve will automatically power off when it is in place.
- 3. The black wire of the controller is connected to the positive line of the power supply and the negative line of the power supply is connected to the valve, the valve will open the valve. Until the valve is in place, the valve will self-power off after it is in place.
- 4. Manual switch: Pull the clutch pull ring down to manually open and close the valve.
This product is used with a gas alarm and is mounted on a manual valve with a stem. After the alarm, the valve is closed by driving the torsion arm with current. Automatic power off when in place.